Northgate Tree ServiceAugusta-Richmond County, GA (762) 320-1410

Local Tree Trimming in Augusta-Richmond County, GA

Branches rubbing the roof, shading out the lawn or crowding the kitchen window are usually a trimming job, not a removal.

Fast Scheduling

  • Free Estimates
  • Straight answers, no sales pitch
Tree Trimming in Augusta-Richmond County

Request an Estimate

No obligation

Call (762) 320-1410

What happens next

  1. Call or send the form
  2. A local pro follows up
  3. Get a straight answer

We'll give you a call back during business hours.

Submitting this form shares the details you enter with a local provider who can contact you about your inquiry. We don't sell your information. See our Privacy Policy.

By entering your phone number, you're OK with us and the local provider texting you about your request. Message frequency varies; msg & data rates may apply. Reply STOP to opt out, HELP for help. See the SMS section of our Privacy Policy.

If that's your tree, call Northgate Tree Service in Augusta-Richmond County and tell us roughly how tall it is and what the branches are touching. The call gets you a ballpark, and the written price follows a visit to the tree.

How much does tree trimming cost in Augusta-Richmond County?

Trimming a tree under 25 feet costs $70 to $325 in Augusta-Richmond County. Ask Northgate Tree Service for a ballpark by phone. The exact price is written up after we look at the tree and before any cutting starts. Crown density, how much comes off, and access set where you land.

A single tree you can reach easily from open ground costs the least. A row of mature trees with dense crowns and tight clearances pushes toward the top. The range covers trees under 25 feet. Taller trees get their own written quote.

Many projects also need tree pruning. Shopping for tree service augusta in Augusta-Richmond County? Our home page has more.

Worth a read: Tree Service Augusta Step by Step: What the Job Involves · Hiring a Tree Service Augusta Contractor: Questions Worth Asking First

What pushes the price up or down?

Crown density, access and tree count move the price most. A crown full of crossing branches, water sprouts and dead wood takes more individual cuts than an open one, and a tree pressed against a deck or fence takes more hand work than one in an open yard.

A young tree that hasn't been touched in years usually has an open structure, so the cuts go quickly. A mature tree left to itself needs a deliberate cut for each crossing branch, sprout and dead limb, not a bulk chop. Branches resting on the roofline or a fence, or hanging low over a driveway where a truck has to pass, are part of the scope even when clearing them means reaching deeper into the crown. Where we can't stage equipment, or a shared fence line means working by hand to protect your neighbor's property, expect the higher side of the range. Each additional tree adds its own work.

Tree trimming example

What does the trimming itself involve?

Before any cut, we look the tree over from the ground, decide which branches go, and cut those rather than whatever is easiest to reach. Branches up to ¾ inch get pruning shears, and up to 1½ inches get lopping shears. The aim is an open crown that lets light through without leaving the tree lopsided.

Every cut ends the same way. We make the last cut outside the branch collar, the swollen ring where the branch meets the trunk, so the collar stays whole and no stub is left.

What if a limb is too thick for the loppers?

A limb thicker than 1½ inches gets two cuts before the final one, so its weight can't tear bark down the trunk. The first is an undercut about 18 inches from the trunk, taken between a third and a half of the way through the limb. The second goes about an inch farther out, and we keep cutting until the limb breaks free.

Once the limb is down, the remaining stub is taken back with the collar cut described above. If a limb is too big or too high for those cuts to be made safely, we'll say so when we quote it rather than improvise.

Do I need a permit to trim a tree here?

Augusta's permit rule is about removal. Trimming a tree that stays standing is a different job, but if the tree is public or might be protected, mention it when you phone.

That way the permit question gets settled before anything is cut. If what you really want is the tree gone, say that up front too, because that's where the permit comes in.

What happens when I call?

We'll ask for a rough height, which branches are causing trouble, and whether they hang over the roof, a fence or the driveway. With that, Northgate Tree Service quotes a ballpark figure right there. Nothing gets booked on that call.

If the range suits you, we come out, look at the crown and the access, and write up the exact price. Nothing gets cut until you've seen it.

What the Job Includes

For work like this, some of what gets done:

  • Remove dead, dying, diseased, weakly attached, or low-vigor branches from the crown.
  • For added clearance, selectively trim lower branches.

Related Services

Fast Scheduling

A brief call tells us most of what we need, and you'll get a clear answer.

← Back to tree service augusta in Augusta-Richmond County